Frintelis

Lane should-cost · Romania → Germany

What does a Timișoara–Munich full truckload cost?

A 995 km lane via Nădlac, Budapest, Vienna and Salzburg, rebuilt from the road up: fuel, driver time, tolls, the truck and the carrier's margin. The result is what the work costs to perform, which is the number to hold a quote against.

Published 13 November 2026 · Lane: Timișoara (RO) → Munich (DE) · Equipment: standard curtainsider semi-trailer · Fuel basis: week of 28 September 2026

€1,980Should-cost / trip
€1.990Per loaded km
€60.00Per pallet (33)
76%Fuel, labour, tolls

The short answer

The modelled should-cost of a Timișoara to Munich full truckload is €1,980 per trip, or €1.990 per loaded kilometre, on a Romanian driver base and diesel at €2.27 per litre. Fuel is the largest element at €728, followed by tolls at €461 and driver labour at €307. A quote for this lane can be read against that figure line by line.

What assumptions is the lane costed on?

Model inputs. Every figure on this page follows from this table. Distance and country split are planner figures for the route described; drive time comes from the engine's distance model.
InputValue used in the model
Origin → destinationTimișoara (RO) → Munich (DE), via Nădlac, Budapest, Vienna and Salzburg
Lane distance995 km loaded — RO 100 km, HU 390 km, AT 365 km, DE 140 km
Empty running100 km → 1,095 effective km
EquipmentStandard curtainsider semi-trailer · 90 m³ · 33 pallets · 24 t payload · 3 years old
Labour baseRomanian driver · 2.3 driver days · per diem applied separately
Fuel€2.27 / litre (week of 28 September 2026, origin and destination average) · 29.3 l/100 km · 321 litres per trip
Loading / unloading2 hours + 2 hours, no chargeable waiting
Driving time15 h 58 including statutory breaks (EU 561/2006)
TollsPer-country distance tariffs, 40 t five-axle Euro VI, net of VAT (RO · HU · AT · DE)

Where does the money go?

Bar chart of the nine cost elements of a Timișoara–Munich truckload, led by fuel at €728, tolls at €461 and driver labour at €307.
Cost breakdown as returned by the Frintelis should-cost engine. € / km is per loaded kilometre.
Cost element€ / km€ / tripShare
Fuel0.73272836.8%
Tolls0.46446123.3%
Driver labour — Romanian driver0.30930715.5%
Maintenance & tyres0.1061055.3%
Depreciation0.099985.0%
Profit margin0.095944.8%
Overhead (SG&A)0.073733.7%
Per diem0.058582.9%
Insurance & taxes0.055552.8%
Total should-cost1.9901,980100%

Reading the stack

How much are the tolls between Timișoara and Munich?

Toll per country for a 40-tonne, five-axle Euro VI combination, net of VAT.
CountrykmToll€ / km
Romania100€80.075
Hungary390€1960.503
Austria365€2090.572
Germany140€490.348
Total995€4610.464

What could move the number?

Each row is a full re-run of the model with one input changed.
ChangeEffect / tripvs baseCommercial question
Diesel +10%+€80+4.0%Which index, baseline and adjustment frequency apply?
German driver base instead of Romanian+€445+22.5%Which establishment country does the offer assume?
Empty running +100 km+€108+5.5%Can the carrier evidence its backhaul on this lane?
Three chargeable waiting hours+€108+5.5%When does detention start, and at what hourly rate?
Margin +2 points+€38+1.9%Is margin taken on cost or on revenue?

The lane is costed on a Romanian driver base, the origin country. Run on a German driver base the same trip models at €2,425, which is €445 higher. That is the largest single lever in the table, so the establishment country behind an offer should be stated, not assumed.

Three chargeable hours of waiting cost €108, about €36 an hour. If a quote carries a dwell contingency, it belongs in a detention clause with a free period and an hourly rate, where it is paid only when the delay happens.

What does the lane cost per pallet?

The same trip in the units that travel into a category P&L, at full utilisation.
UnitAt should-cost
Cost per trip€1,980
Cost per loaded km€1.990
Cost per pallet (33 pallets)€60.00
Cost per m³ (90 m³)€22.00
Cost per kg (24 t payload)€0.082

How to read a quote against it

Fuel, labour and tolls are €1,497 of the €1,980: road cost that any compliant carrier on this lane has to absorb. The commercial conversation concerns the remaining €483 of asset, overhead and margin.

Four questions to take into the carrier meeting

  1. Which labour-cost base and establishment country does the offer assume?
  2. How much empty running is priced in, and what network evidence supports it?
  3. Which items are fixed, which indexed, and which treated as verifiable pass-through?
  4. What loading and waiting time is included in the linehaul, and when does detention begin?
Interpretation note

A should-cost result is a decision anchor, not a price ceiling. Market imbalance, capacity, service conditions and carrier network economics can all justify a rate above the model. The purpose is to know how much of a quote the carrier is being asked to explain.

Method and scope

Figures are produced by the Frintelis should-cost engine from the lane inputs in the assumptions table and a dated European reference set covering fuel, labour, toll, asset, maintenance and overhead cost. The model is deterministic: identical inputs return an identical result. Fuel prices are pump prices from the EU Weekly Oil Bulletin for the week of 28 September 2026; tolls are net of VAT.

This is a cost model, not a market price index. It does not observe transacted rates and it does not forecast them. In the application the same lane can be re-run with your own distance, equipment, waiting time and labour base.

Other lanes

Need this for your own lanes?

1 — Frintelis, the platform

Model your own lanes, run sensitivity testing and export the breakdown for your tender file. Currently in an invitation-only pilot.

Request pilot access

2 — Advisory: tender and cost-model support

Should-cost positions for your lane set before quotes come in, and a structured read of the field once they do. Independent: not a 4PL, not a broker, no carrier commissions.

Email Gyorgy Connect on LinkedIn